Hot Alps (Invited)
Abstract
Although it is frequently assumed that crust of Alpine orogens is hot due to the occurrence of thick and young (hence radiogenic) crust, evidence on the thermal ranking of orogens is contradictory. Heat flow measurements from shallow wells (depth ≤ 1 km) in the Alps yield a relatively cold thermal regime of 50-80 mW/m2, but data are likely biased by meteoric cold-water circulation. Here we report on the spectral analysis of the aeromagnetic residuals of northern Italy to derive the Curie point depth (CPD), assumed to represent the 600°C isotherm depth. Airborne magnetics were acquired on whole Italy during the 1970s by the national oil company AGIP (now Eni). Data were gathered by several surveys carried out at 1000-13,300 feet (300-4000 m) altitude, with flight line spacing of 2-10 km. Surveys of the Alps and Po Plain (northern Italy) were obtained both with a line spacing of 5 km (and 5 km tie lines), at an altitude of 4000-5000 and 13,300 feet, respectively. To evaluate CPDs we used the centroid method (routinely adopted in recent CPD studies on East Asia and central-southern Europe) on 72 square windows of 100-110 km edge, with a 50% degree of superposition. CPDs vary between 16 and 38 km (22 km on average) in the Po Plain, located south of the Alps and representing the Adriatic-African foreland area. Conversely, the Alps yield very shallow CPDs, ranging between 6 and 15 km (10 km on average). CPDs fall systematically above local Moho depths, implying that magnetic source bottoms documented in this study do not represent a lithological boundary over non-magnetic peridotitic mantle, but can be safely associated with CPDs and the 600°C isotherm. CPDs from the Po Plain are in rough agreement with reported heat flow values of 25-60 mW/m2, and imply and average thermal conductivity (k) of the Po Plain crust of 1.5 W/m°K, at the lower bound of k values measured and inferred for the crust. Conversely, the average 10 km CPD documented in the Alps translates into heat flow values ranging from 90 to 150 mW/m2, if k values of 1.5 to 2.5 W/m°K (respectively) are assumed (the latter is average k value of the crust assumed for other world provinces, such as California). A ~150 mW/m2 heat flow value turns out to be similar to that observed in Tuscany and the Tyrrhenian Sea back-arc basin, as well as to values documented for active rifts and young oceans. Di Stefano et al. (2009) documented P wave velocities around 8 km/sec in the upper mantle of the Alps, suggesting the lack of shallow asthenosphere. Thus high heat flow of the Alps must be produced by radiogenic crust, instead of asthenospheric upwelling. A 600°C isotherm at ~10 km depth implies widespread melting at mid-lower crustal depths, considering the 60 km crustal thickness of the Alps. This is consistent with the very low P-wave velocities observed at 20-40 km depth beneath the chain by Di Stefano et al. (2009). When extrapolated to other orogens of the geological past, the thermal regime of the Alps may explain the extensive occurrence of intrusives exposed in eroded pre-Alpine orogens and cratons. Reference: Di Stefano, R., et al. (2009), J. Geophys. Res., 114, doi:10.1029/2008JB005641.
- Publication:
-
AGU Fall Meeting Abstracts
- Pub Date:
- December 2013
- Bibcode:
- 2013AGUFMGP44A..05S
- Keywords:
-
- 1517 GEOMAGNETISM AND PALEOMAGNETISM Magnetic anomalies: modeling and interpretation;
- 8130 TECTONOPHYSICS Heat generation and transport