Stress History During Exhumation from HP-LT Metamorphic Conditions - Transient Deformation at Low and High Stress-Loading Rates in a Ductile Extensional Shear Zone, Central Crete
Abstract
In an extensional shear zone in the Talea Ori, Crete, quartz veins occur in high-pressure low-temperature metamorphic sediments at sites of dilation along shear band boundaries, kink band boundaries and boudin necks. Bent elongate grains grown epitactically from the host rock with abundant fluid inclusion trails parallel to the vein wall indicate vein formation by crack-seal increments during dissolution-precipitation creep of the host rock. The presence of sutured high-angle grain boundaries and subgrains shows that temperatures were sufficiently high for recovery and strain-induced grain boundary migration, i.e. higher than 300-350 °C, close to peak metamorphic conditions. The generally low amount of strain accumulated by dislocation creep in quartz of the host rock and most veins indicates low bulk stress conditions of a few tens of MPa on a long term. The time scale of stress-loading to cause cyclic cracking and sealing is assumed to be lower than the Maxwell relaxation time of the metasediments undergoing dissolution-precipitation creep at high strain rates (10-10 s-1 to 10-9 s-1), which is on the order of hundred years. In contrast, some veins discordant or concordant to the foliation show heterogeneous quartz microstructures with micro-shear zones, sub-basal deformation lamellae, short-wavelength undulatory extinction and recrystallized grains restricted to high strain zones. These microstructures indicate dislocation glide-controlled crystal-plastic deformation (low-temperature plasticity) at transient high stresses of a few hundred MPa with subsequent recovery and strain-induced grain boundary migration at relaxing stresses and temperatures of at least 300-350 °C. High differential stresses in rocks at greenschist-facies conditions that relieve stress by creep on the long term, requires fast stress-loading rates, presumably by seismic activity in the overlying upper crust. The time scale for stress loading is controlled by the duration of the slip event along a fault, i.e. a few seconds to minutes. This study demonstrates that microstructures can distinguish between deformation at internal low stress-loading rates (to tens of MPa on a time scale of hundred years) and high (coseismic) stress-loading rates to a few hundred MPa on a time scale of minutes.
- Publication:
-
AGU Fall Meeting Abstracts
- Pub Date:
- December 2018
- Bibcode:
- 2018AGUFM.T32B..02S
- Keywords:
-
- 3902 Creep and deformation;
- MINERAL PHYSICSDE: 8004 Dynamics and mechanics of faulting;
- STRUCTURAL GEOLOGYDE: 8159 Rheology: crust and lithosphere;
- TECTONOPHYSICSDE: 8434 Magma migration and fragmentation;
- VOLCANOLOGY