A potential third-generation gravitational-wave detector based on autocorrelative weak-value amplification
Abstract
Reducing noises and enhancing signal-to-noise ratios (SNRs) have become critical for designing third-generation gravitational-wave (GW) detectors with a GW strain of less than $10^{-23}~{\mathrm{\sqrt{Hz}}}^{-1}$ . In this paper, we propose a potential third-generation GW detector based on autocorrelative weak-value amplification (AWVA) for GW detection with a strain of $h_g = ~4 \times 10^{-25}~{\mathrm{\sqrt{Hz}}}^{-1}$ . In our scheme, a GW event induces a phase difference $\Delta \phi$ by passing through a 11-bounce delay line, 10-km arm-length, zero-area Sagnac interferometer illuminated with a 1064-nm laser. Subsequently, $\Delta \phi$ is amplified as the parameter of post-selection by choosing the appropriate pre-selected state and coupling strength in AWVA. In particular, we theoretically investigate the AWVA measurements for GW detection within the frequency band of 200 Hz $\leqslant~f_g~\leqslant$ 800 Hz, considering Gaussian noises with negative-decibel SNRs. The peak response of the AWVA sensitivity $\kappa(f_g)$ occurs at frequency $f_{g, \mathrm{max}}$ = 500 Hz, which falls within the frequency band of interest of the current third-generation GW detectors. Our simulation results indicate that AWVA can demonstrate a measurable sensitivity of the autocorrelation coefficient $\Theta(f_g)$ within the frequency band of interest. Moreover, the robustness of WVA shows promising potential in mitigating the effects of Gaussian noises.
- Publication:
-
Classical and Quantum Gravity
- Pub Date:
- September 2023
- DOI:
- 10.1088/1361-6382/aceb47
- arXiv:
- arXiv:2306.06827
- Bibcode:
- 2023CQGra..40r5003H
- Keywords:
-
- weak measurement;
- gravitational-wave detection;
- weak-value amplification;
- zero-area Sagnac interferometer;
- General Relativity and Quantum Cosmology;
- Astrophysics - Instrumentation and Methods for Astrophysics
- E-Print:
- 21 pages, 6 figures