On flow disturbances caused by pressure taps in highly elastic flows around a microfluidic cylinder

The objective of this work is to characterize the onset of laterally asymmetric flow of viscoelastic solutions around a confined microfluidic cylinder, which was encountered in a recent study [Rodrigues et al., J. Non-Newtonian Fluid Mech. 289, 104406 (2020)]. To this end, two non-Newtonian fluids were employed in the same micro-geometry. Two microchannels were studied, both with a cylinder of diameter 75 μm, aspect ratio (channel height over width) of 0.37, and blockage ratio (cylinder diameter over channel width) of 0.28, differing only on the width of the pressure taps, located 500 μm up- and downstream from the respective cylinder face, on opposing walls. The working fluids consist of two poly(ethylene oxide) solutions: an elastic weakly shear-thinning fluid and an elastic shear-thinning fluid. Micro-Particle Image Velocimetry and streak imaging techniques were used to evaluate the flow over a Weissenberg number range 100 ≤ W i ≤ 500, while maintaining a low Reynolds number, Re < 1. The elastic shear-thinning solution showed laterally asymmetric flow past the cylinder with both pressure tap designs, while with the weakly shear-thinning solution asymmetric flow was only observed with the wider pressure tap intake. In both cases, the fluids preferentially chose the cylinder/wall gap opposing the upstream pressure tap, which was found to influence the flow greatly, seemingly associated with time-dependent flow and possibly the lateral flow asymmetry itself. This work brings to light the necessary compromise between optimal pressure tap design for quality pressure measurements and minimal flow interference, due to the increased susceptibility of elastic microfluidic flows to flow perturbations.