Achievable Rate and Energy Efficiency of Hybrid and Digital Beamforming Receivers with Low Resolution ADC
Abstract
For 5G it will be important to leverage the available millimeter wave spectrum. To achieve an approximately omni- directional coverage with a similar effective antenna aperture compared to state of the art cellular systems, an antenna array is required at both the mobile and basestation. Due to the large bandwidth and inefficient amplifiers available in CMOS for mmWave, the analog front-end of the receiver with a large number of antennas becomes especially power hungry. Two main solutions exist to reduce the power consumption: Hybrid BeamForming (HBF) and Digital BeamForming (DBF) with low resolution ADC. Hybrid beamforming can also be combined with low resolution ADCs. This paper compares the spectral and energy efficiency based on the chosen RF-frontend configuration. A channel with multipath propagation is used. In contrast to previous publication, we take the spatial correlation of the quantization noise into account. We show that the low resolution ADC are robust to small Automatic Gain Control (AGC) imperfections. We showed that in the low SNR regime the performance of DBF even with 1-2 bit resolution outperforms HBF. If we consider the relationship of spectral and energy efficiency then DBF with 3-5 bits resolution achieves the best ratio of spectral efficiency per power consumption of the RF receiver frontend over a very wide SNR region. The power consumption model is based on components reported in literature.
- Publication:
-
arXiv e-prints
- Pub Date:
- October 2016
- DOI:
- 10.48550/arXiv.1610.02909
- arXiv:
- arXiv:1610.02909
- Bibcode:
- 2016arXiv161002909R
- Keywords:
-
- Computer Science - Information Theory
- E-Print:
- submitted to JSAC special issue on mmWave