Canonical single field slow-roll inflation with a non-monotonic tensor-to-scalar ratio

We take a pragmatic, model independent approach to single field slow-roll canonical inflation by imposing conditions, not on the potential, but on the slow-roll parameter epsilon(phi) and its derivatives epsilon'(phi) and epsilon''(phi), thereby extracting general conditions on the tensor-to-scalar ratio r and the running n_sk at phi_H where the perturbations are produced, some 50-60 e-folds before the end of inflation. We find quite generally that for models where epsilon(phi) develops a maximum, a relatively large r is most likely accompanied by a positive running while a negligible tensor-to-scalar ratio implies negative running. The definitive answer, however, is given in terms of the slow-roll parameter ξ₂(phi). To accommodate a large tensor-to-scalar ratio that meets the limiting values allowed by the Planck data, we study a non-monotonic epsilon(phi) decreasing during most part of inflation. Since at phi_H the slow-roll parameter epsilon(phi) is increasing, we thus require that epsilon(phi) develops a maximum for phi > phi_H after which epsilon(phi) decrease to small values where most e-folds are produced. The end of inflation might occur trough a hybrid mechanism and a small field excursion Δphi_e ≡ |phi_H-phi_e| is obtained with a sufficiently thin profile for epsilon(phi) which, however, should not conflict with the second slow-roll parameter η(phi). As a consequence of this analysis we find bounds for Δphi_e, r_H and for the scalar spectral index n_sH. Finally we provide examples where these considerations are explicitly realised.