Physical Properties of Gabbroic Rock Exposed in Oceanic Core Complexes- New Borehole Data From IODP Hole U1473A in the Indian Ocean and Prior Mid-Atlantic Ridge Results

IODP Expedition 360 to Atlantis Bank on the Southwest Indian Ridge obtained physical property measurements of the 800 m section drilled into the footwall of the oceanic core complex. Compressional velocity (Vp) of core samples range from 5.9-7.2 km/s throughout the hole, with no simple relation to either basic rock type or alteration. Some intervals show a local trend, for example a general increase from 6.7-7.1 km/s over the interval 280-400 mbsf, above a major fault zone at 411-462 mbsf. Below the fault zone, core sample Vp is lower on average (6.6 km/s) than it is in the upper part of the hole (6.8 km/s). Some of this decrease is due to locally greater alteration, but higher oxide content also contributes. Borehole logs show lower Vp shallower than 400 m (6.3-6.4 km/s) and close match to olivine gabbro values below the fault zone, due to higher alteration levels and greater shallow fracturing. Local trends of decreasing Vp, over 10's of m correspond to increasing sample porosity within veined or fractured intervals. Porosities of core in Hole U1473A are low overall (<4.5%) and more variable above 570 mbsf than below. Electrical resistivity of the wallrock tracks logged velocity pattern, dropping below 100 ohm-m in altered or fractured intervals 20-50 m thick and rising over 1000 ohm-m where fresher rock was recovered. The range of velocity, density, and resistivity at Hole U1473A are similar to those in the other deep boreholes from Atlantis Bank (ODP Hole 735B, 1105A) and slightly higher than Vp in the gabbroic core of Atlantis Massif in the Atlantic, Hole U1309D. This may reflect erosion of the detachment zone when the bank was exposed at sealevel. Atlantis Massif displays an increase in Vp from the seafloor to a fault zone at 750 mbsf ( 4.0-6.2 km/s), followed by fairly constant values ( 6.7 km/s) at greater depths, interrupted by a highly altered olivine-rich troctolite interval 1080-1200 mbsf where velocity is up to 1 km/s slower. New analysis of seismic anisotropy based on sonic logs does not show any systematic signature for either core complex, but there are a few intervals up to 10 m thick where anisotropy due to local deformation or dominant fracture direction may be indicated. The new and prior borehole data will be presented in the context of available geophysical, lithologic and alteration results.