Hydraulic experiment on tsunami sand deposits relating with grain size distribution and magnitude of incident waves

A huge earthquake occurred off the Tohoku district in Japan on March 11th, 2011. A massive tsunami generated by the earthquake attacked coastal areas and caused serious damage. The tsunami disaster requires to reconsider tsunami measures in the Nankai Trough. Many of the measures are based on histories of large earthquakes and tsunamis. Because they are low frequency disasters and their historical documents are limited, tsunami sand deposits have been expected to analyze paleotsunamis. Tsunami sand deposits, however, are only used to confirm the fact of tsunamis and to determine the relative magnitudes. The thickness of sand layer and the grain size may be clues to estimate the tsunami force. Further, it could reveal the tsunami source. These results are also useful to improve the present tsunami measures. The objective of this study is to investigate the formation mechanism of tsunami sand deposits by hydraulic experiment. A two-dimensional water channel consisted of a wave maker, a flat section and a slope section. A movable bed section with various grain sizes and distribution of sand was set at the end of flat section. Bore waves of several heights transported the sand to the slope section by run-up. Water surface elevation and velocity were measured at several points. Tsunami sand deposit distribution was also measured along the slope section. The experimental result showed that the amount of tsunami sand deposit was relating with the grain size distribution and the magnitude of incident waves. Further, the number of incident waves affected the profile of tsunami sand deposits.