The method of assessment of the grinding wheel cutting ability in the plunge grinding
Abstract
This article presents the method of comparative assessment of the grinding wheel cutting ability in the plunge grinding kinematics. A new method has been developed to facilitate multicriterial assessment of the working conditions of the abrasive grains and the bond bridges, as well as the wear mechanisms of the GWAS, which occur during the grinding process, with simultaneous limitation of the workshop tests range. The work hereby describes the methodology of assessment of the grinding wheel cutting ability in a short grinding test that lasts for 3 seconds, for example, with a specially shaped grinding wheel, in plunge grinding. The grinding wheel macrogeometry modification applied in the developed method consists in forming a cone or a few zones of various diameters on its surface in the dressing cut. It presents an exemplary application of two variants of the method in the internal cylindrical plunge grinding, in 100Cr6 steel. Grinding wheels with microcrystalline corundum grains and ceramic bond underwent assessment. Analysis of the registered machining results showed greater efficacy of the method of cutting using a grinding wheel with zones of various diameters. The method allows for comparative tests upon different grinding wheels, with various grinding parameters and different machined materials.
- Publication:
-
Central European Journal of Engineering
- Pub Date:
- September 2012
- DOI:
- 10.2478/s13531-012-0005-5
- Bibcode:
- 2012CEJE....2..399N
- Keywords:
-
- Plunge grinding;
- Internal cylindrical grinding;
- Grinding wheel wear;
- Microcrystalline sintered corundum;
- Glass-crystalline bond