Modeling right-lateral offset of a Late Pleistocene terrace riser along the Polaris fault using ground based LiDAR imagery
Abstract
High resolution (centimeter level) three-dimensional point-cloud imagery of offset glacial outwash deposits were collected by using ground based tripod LiDAR (T-LiDAR) to characterize the cumulative fault slip across the recently identified Polaris fault (Hunter et al., 2009) near Truckee, California. The type-section site for the Polaris fault is located 6.5 km east of Truckee where progressive right-lateral displacement of middle to late Pleistocene deposits is evident. Glacial outwash deposits, aggraded during the Tioga glaciation, form a flat lying ‘fill’ terrace on both the north and south sides of the modern Truckee River. During the Tioga deglaciation melt water incised into the terrace producing fluvial scarps or terrace risers (Birkeland, 1964). Subsequently, the terrace risers on both banks have been right-laterally offset by the Polaris fault. By using T-LiDAR on an elevated tripod (4.25 m high), we collected 3D high-resolution (thousands of points per square meter; ± 4 mm) point-cloud imagery of the offset terrace risers. Vegetation was removed from the data using commercial software, and large protruding boulders were manually deleted to generate a bare-earth point-cloud dataset with an average data density of over 240 points per square meter. From the bare-earth point cloud we mathematically reconstructed a pristine terrace/scarp morphology on both sides of the fault, defined coupled sets of piercing points, and extracted a corresponding displacement vector. First, the Polaris fault was approximated as a vertical plane that bisects the offset terrace risers, as well as bisecting linear swales and tectonic depressions in the outwash terrace. Then, piercing points to the vertical fault plane were constructed from the geometry of the geomorphic elements on either side of the fault. On each side of the fault, the best-fit modeled outwash plane is projected laterally and the best-fit modeled terrace riser projected upward to a virtual intersection in space, creating a vector. These constructed vectors were projected to intersection with the fault plane, defining statistically significant piercing points. The distance between the coupled set of piercing points, within the plane of the fault, is the cumulative displacement vector. To assess the variability of the modeled geomorphic surfaces, including surface roughness and nonlinearity, we generated a suite of displacement models by systematically incorporating larger areas of the model domain symmetrically about the fault. Preliminary results of 10 models yield an average cumulative displacement of 5.6 m (1 Std Dev = 0.31 m). As previously described, Tioga deglaciation melt water incised into the outwash terrace leaving terrace risers that were subsequently offset by the Polaris fault. Therefore, the age of the Tioga outwash terrace represents a maximum limiting age of the tectonic displacement. Using regional age constraints of 15 to 13 kya for the Tioga outwash terrace (Benson et al., 1990; Clark and Gillespie, 1997; James et al., 2002) and the above model results, we estimate a preliminary minimum fault slip rate of 0.40 ± 0.05 mm/yr for the Polaris type-section site.
- Publication:
-
AGU Fall Meeting Abstracts
- Pub Date:
- December 2009
- Bibcode:
- 2009AGUFM.G51B0661H
- Keywords:
-
- 1209 GEODESY AND GRAVITY / Tectonic deformation;
- 3252 MATHEMATICAL GEOPHYSICS / Spatial analysis;
- 7221 SEISMOLOGY / Paleoseismology;
- 8040 STRUCTURAL GEOLOGY / Remote sensing