Effective Elastic Thickness Variations Along the Andean Margin and Their Relationship to Subduction Geometry
Abstract
We present a new map of spatial variations in effective elastic thickness, Te, along the Andes, estimated using Bouguer coherence. The Te variations reflect interactions between subducting slab and pre-existing terrane structure. In the forearc, conductive cooling of the continent by the subducting slab exerts primary control on rigidity, resulting in Te that is highest (~ 40 km) where the oceanic lithosphere is oldest and coldest (~ 20° S). In the central Andes, Te is relatively low (~ 20 km) along the volcanic chain, the Altiplano and Puna plateaus. We interpret this weakening to reflect a high geothermal gradient maintained by advective magmatic processes, a shallow and hot asthenosphere, and a very weak lower crust throughout this region. East of the plateaus, high Te delineates underthrusting of the Brazilian shield. North and south of the plateaus, areas experiencing flat subduction are characterized by high Te, high shear wave velocity, thick thermal boundary layer and low heat flow, indicating that continental lithosphere there is thicker, colder and stronger. Based on these relationships we suggest that variations in slab dip along the margin relate to variations in structure of the continental lithosphere. In particular, we propose that upper plate structure influences the width and viscosity of the asthenospheric wedge, which control the suction moment responsible for the subduction angle at depths ~ 70--100 km. When oceanic lithosphere subducts beneath thin continental lithosphere, the low viscosity asthenosphere allows the slab to detach from the continent and sink into the mantle at normal angles. However, when oceanic lithosphere subducts near or beneath thick and strong continental lithosphere, the asthenospheric wedge narrows and corner flow drags high viscosity mantle from the base of the thick (> 150 km), cold continent into the wedge. Suction forces increase both with narrowing of the wedge and with increasing viscosity. We estimate the asthenospheric viscosity underneath thick, cold continents to be > 1020 Pa s, sufficient to induce flat subduction. Later, after prolonged hydration and weakening of the continent's base, asthenospheric flow into the wedge may resume, allowing the slab to sink again into the mantle at normal angles.
- Publication:
-
AGU Fall Meeting Abstracts
- Pub Date:
- December 2007
- Bibcode:
- 2007AGUFM.T31A0286P
- Keywords:
-
- 8104 Continental margins: convergent;
- 8120 Dynamics of lithosphere and mantle: general (1213);
- 8138 Lithospheric flexure;
- 8162 Rheology: mantle (8033);
- 8170 Subduction zone processes (1031;
- 3060;
- 3613;
- 8413)