Study of the influence of microstructural properties on the sliding-wear behavior of HVOF and HVAF sprayed WC-cermet coatings

The microstructural properties of WC-Co-Cr and WC-Co coatings deposited by high-velocity oxygen fuel (HVOF) and high-velocity air fuel (HVAF) processes were investigated. The tribological behavior of the coatings was studied by means of pin-on-disk tests. Microcracking of the HVOF sprayed WC-Co coatings did not allow preparation of suitable disks for wear tests. The wear rates of the remaining coatings were determined, and wear tracks on the coatings and counterbodies were investigated by SEM. The HVAF sprayed coatings showed greater sliding-wear resistance compared to the HVOF coatings. The prime wear mechanism in the WC-Co HVAF coatings was adhesive wear. The cobalt matrix is lubricious, resulting in very low wear rates and low debris generation. The main wear mechanisms in the WC-Co-Cr coatings were adhesive and abrasive wear. Adhesive wear results in coating material dislodgments (i.e., "pullouts") that become trapped in the contact zone and act as a third-body abrasive. Particle pullout from the coating significantly increases the wear rate of the coated specimen. The HVAF/WC-Co-Cr coatings exhibited better resistance to particle pullout, resulting in a considerably lower wear rate than the HVOF/WC-Co-Cr coatings.